Skip to main content

6MFS

6MFS Committee

All 6MFS Topics

6MFS Calendar

Aviation

Airtankers

Felling Safety

Fire Communication

Firefighter Health & First Aid

Leadership

Misc Fireline Hazards

Operational Engagement

This Day in History

Vehicles - Roads

Weather - Fire Behavior

Week of Remembrance

Active Shooter – How to Respond

 

Run, Hide, Fight – Active Shooter Protocols

Good practices for coping with an active shooter situation:

  1. Be aware of your surroundings.
  2. Take note of the two nearest exits in any facility you visit.
  3. If you are in an office, stay in the office and secure the door.
  4. If you are in a hallway, get into a room and secure the door.
  5. As a last resort, attempt to take the active shooter down. When the shooter is at close range and you cannot flee, your chance of survival is much greater if you try to incapacitate the individual.
  6. Behaviors to look for in an active shooter (review Department of Homeland Security [DHS] link below in references).

**Call 911 only when it is safe to do so**

How to respond when law enforcement arrives:

  1. Remain calm and follow officers’ instructions.
  2. Put down any items in your hands (i.e., bags, jackets).
  3. Immediately raise hands and spread fingers.
  4. Keep hands visible at all times.
  5. Avoid making quick movements toward officers such as holding onto them for safety.
  6. Avoid pointing, screaming, and/or yelling.
  7. Do not stop to ask officers for help or direction when evacuating, just proceed in the direction from which officers are entering the premises.

Training your staff for an active shooter situation:

  1. Create an Emergency Action Plan (EAP).
    1. Implement training exercises based off the EAP.
  2. Preparedness and Prevention.
    1. DHS Active Shooter Situation – Options to Consider video –  https://youtu.be/yz5P2wy4X4o.

Discussion Questions:

  1. What are some considerations to help you be prepared to react appropriately in an active shooter situation on the fireline? At the Incident Command Post (ICP)?
  2. Do you know the location of the closest Law Enforcement?
  3. What about at ICP or Helibase?
    1. Does your Incident Management Team or module have an EAP that addresses the potential active shooter scenario?
    2. If an active shooter situation occurs at ICP, do you have the Security Manager’s number, so they can immediately send the closest Law Enforcement Officer, or do you call Communications on the radio?
Category
Firefighter Health & First Aid

6MFS Suggestion Form


Have an idea or feedback?

Share it with the NWCG 6MFS Subcommittee
 


Follow NWCG on X and Facebook
 


 

Last Modified / Reviewed:

Print PDF

NWCG Latest Announcements

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

Date: June 3, 2025
Questions?  Please contact:
Emergency Medical Committee

The Emergency Medical Committee has issued interim guidance for Rapid Extraction Module Support (REMS) teams. Until further notice, Type I and II REMS teams must designate a team leader qualified at Firefighter Type 1 Squad Boss (FFT1) or higher. This temporary change replaces the Single Resource Boss (SRB) requirement, which is currently not feasible due to administrative barriers.

This memorandum does not include any other changes to the NWCG Standards for Rapid Extraction Module Support, PMS 552. This interim change takes effect immediately and will remain in place until further notice.

References:

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

NWCG Standards for Rapid Extraction Module Support, PMS 552

Equipment Bulletin 25-002: Chaps, Chain Saw, M-2020, Nonconformities Affecting Use, Appearance, and Serviceability

Date: June 2, 2025
Questions?  Please contact:
Equipment Technology Committee

The Equipment Technology Committee issued Equipment Bulletin: 25-002 to address a manufacturing nonconformity affecting Forest Service specification, 6170-4K Chain Saw Chaps. The issue applies to chaps manufactured in 2024 and 2025 and distributed through FedMall. These chaps may have incorrectly bound edges that expose inner protective layers.

Independent purchasers should inspect all chain saw chaps received from FedMall beginning in 2024, prior to use. Review the full Equipment Bulletin: 25-002 for inspection criteria and recommended actions.

References:

NWCG Alerts

ETC Equipment Bulletin: 25-002

2024 Wildland Fire Emergency Medical Service Awards

Date: May 22, 2025
Questions?  Please contact:
Emergency Medical Committee

The NWCG Emergency Medical Committee (EMC) is proud to announce the recipients of the 2024 Wildland Fire Emergency Medical Service Awards. Each year, EMC recognizes individuals and groups who have demonstrated exceptional actions or accomplishments that go above and beyond their normal mission or job duties.

Congratulations to all the awardees and nominees. Through leadership and initiative, they have made significant contributions to the safety and well-being of the wildland fire community. These honors are well deserved.

References:

2024 Wildland Fire EMS Awards

NWCG Emergency Medical Committee

NWCG Welcomes the Incident Management Teams Association as an Associate Member

Date: May 21, 2025
Questions?  Please contact:
https://www.nwcg.gov/contact-us

The NWCG Executive Board is honored to announce that the Incident Management Teams Association (IMTA) has joined the National Wildfire Coordinating Group as an associate member.

IMTA is a dedicated group of incident management professionals committed to enhancing the profession by promoting standards and fostering collaboration across federal, state, local, Tribal, and private sector partners throughout all phases of incident management.

“Joining NWCG aligns with our mission to elevate incident management professionals nationwide,” said Dr. Randal Collins, President of IMTA. “This is a proud moment for all of us committed to advancing public safety.”

References:

Incident Management Teams Association

National Wildfire Coordinating Group