Skip to main content

6MFS

6MFS Committee

All 6MFS Topics

6MFS Calendar

Aviation

Airtankers

Felling Safety

Fire Communication

Firefighter Health & First Aid

Leadership

Misc Fireline Hazards

Operational Engagement

This Day in History

Vehicles - Roads

Weather - Fire Behavior

Week of Remembrance

Fire Shelter Deployment Site Selection

 

A primary objective of every operational fire plan is to keep firefighters out of entrapment situations. However, firefighters must always be prepared to deploy their fire shelters. The key to a successful fire shelter deployment is proper site selection. Consider the following for shelter deployment site selection:

  • Pick a site that will keep the fire shelter away from flames and convective heat. The site also should limit the amount of radiant heat that reaches the shelter.
  • Select an area with no fuels. If that isn't possible, select a site in light fuels, such as grass, where the flaming front will pass quickly. Clear the site to mineral soil if possible. If time is critical, pick a site with the least amount of fuel.
  • Pick natural firebreaks such as wet meadows,creek beds, wet, swampy areas, or large rockslides with no fuels. Rough terrain in rockslides may make it difficult to seal the fire shelter to the ground.
  • Areas on the lee side of ridgetops and knobs can be effective deployment sites because convective heat and flames will generally continue rising above them.
  • Wide areas that have been cleared of fuel, such as dozer lines or roads, can be effective deployment sites. In larger areas, don't let trucks, dozers, and other equipment occupy the best deployment sites.
  • Flat areas on slopes, such as benches or road cuts, offer some protection from radiant and convective heat. Level areas like these can keep you under the path of flames and convective heat.
    • The ditch on the inside of the road, if free of fuel, may be an effective deployment site.
    • Consider vehicle traffic when looking at options on or near roadways.
  • Avoid areas that tend to funnel smoke, flames, and hot gasses, such as:
    • Narrow draws
    • Saddles on ridgetops
    • Chimneys and chutes
  • Know how long it takes to reach your safety zone. Crew supervisors should identify and communicate escape routes and safety zones.
  • If you are not in a suitable shelter deployment area, keep escaping while watching for a possible deployment site.
  • Ensure sites are clearly identified and marked.

Also see: Fire Shelter Deployment

 

Category
Operational Engagement
References
The New Generation Fire Shelter, PMS 411
10 Standard Firefighting Orders, PMS 110
18 Watch Out Situations, PMS 118
10 and 18 Poster, PMS 110-18

6MFS Suggestion Form


Have an idea or feedback?

Share it with the NWCG 6MFS Subcommittee
 


Follow NWCG on X and Facebook
 


 

Last Modified / Reviewed:

Print PDF

NWCG Latest Announcements

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

Date: June 3, 2025
Questions?  Please contact:
Emergency Medical Committee

The Emergency Medical Committee has issued interim guidance for Rapid Extraction Module Support (REMS) teams. Until further notice, Type I and II REMS teams must designate a team leader qualified at Firefighter Type 1 Squad Boss (FFT1) or higher. This temporary change replaces the Single Resource Boss (SRB) requirement, which is currently not feasible due to administrative barriers.

This memorandum does not include any other changes to the NWCG Standards for Rapid Extraction Module Support, PMS 552. This interim change takes effect immediately and will remain in place until further notice.

References:

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

NWCG Standards for Rapid Extraction Module Support, PMS 552

Equipment Bulletin 25-002: Chaps, Chain Saw, M-2020, Nonconformities Affecting Use, Appearance, and Serviceability

Date: June 2, 2025
Questions?  Please contact:
Equipment Technology Committee

The Equipment Technology Committee issued Equipment Bulletin: 25-002 to address a manufacturing nonconformity affecting Forest Service specification, 6170-4K Chain Saw Chaps. The issue applies to chaps manufactured in 2024 and 2025 and distributed through FedMall. These chaps may have incorrectly bound edges that expose inner protective layers.

Independent purchasers should inspect all chain saw chaps received from FedMall beginning in 2024, prior to use. Review the full Equipment Bulletin: 25-002 for inspection criteria and recommended actions.

References:

NWCG Alerts

ETC Equipment Bulletin: 25-002

2024 Wildland Fire Emergency Medical Service Awards

Date: May 22, 2025
Questions?  Please contact:
Emergency Medical Committee

The NWCG Emergency Medical Committee (EMC) is proud to announce the recipients of the 2024 Wildland Fire Emergency Medical Service Awards. Each year, EMC recognizes individuals and groups who have demonstrated exceptional actions or accomplishments that go above and beyond their normal mission or job duties.

Congratulations to all the awardees and nominees. Through leadership and initiative, they have made significant contributions to the safety and well-being of the wildland fire community. These honors are well deserved.

References:

2024 Wildland Fire EMS Awards

NWCG Emergency Medical Committee

NWCG Welcomes the Incident Management Teams Association as an Associate Member

Date: May 21, 2025
Questions?  Please contact:
https://www.nwcg.gov/contact-us

The NWCG Executive Board is honored to announce that the Incident Management Teams Association (IMTA) has joined the National Wildfire Coordinating Group as an associate member.

IMTA is a dedicated group of incident management professionals committed to enhancing the profession by promoting standards and fostering collaboration across federal, state, local, Tribal, and private sector partners throughout all phases of incident management.

“Joining NWCG aligns with our mission to elevate incident management professionals nationwide,” said Dr. Randal Collins, President of IMTA. “This is a proud moment for all of us committed to advancing public safety.”

References:

Incident Management Teams Association

National Wildfire Coordinating Group