Skip to main content

ATV – Transport

All-Terrain Vehicle (ATV) Loading/Unloading

Loading/unloading of ATVs has resulted in serious injury and even death to employees. Only those who have been fully trained in ATV operations should conduct loading/unloading procedures. The following safety measures are recommended:

  • Wear all personal protective equipment (including gloves, helmet, etc.) until ATV is either secured or unloaded.
  • Ensure header board (board placed in front of bed of truck or trailer) is in place and in good condition.
  • ATV tire ramps should be secured to trailer or tailgate and on level terrain.
  • If possible, use a tilt trailer to haul an ATV. If this is not feasible, try to lower back end of vehicle so slant of loading ramp is reduced. Back into a ditch, hillside, or anything else to try and lower back end of vehicle.
  • When loading ATV onto vehicle or trailer, keep seated, and lean body weight forward on ATV.
  • When unloading ATV, keep seated and keep weight forward. This helps keep ATV from flipping over backwards.
  • Never load or unload an ATV with a load on the racks. Load all ATVs empty.

Securing ATV for transport

Improperly loaded ATVs can be dangerous to you and other highway users. Steering can be affected if your load is not properly distributed. If not properly secured, the ATV can become dislodged during a quick stop or crash and damage equipment and cause injury or death.

  • Drivers are responsible for their load—regardless of who actually loads equipment. All drivers are responsible for:
    • Inspecting the ATV.
    • Recognizing overloads and poorly balanced weight.
    • Removing any gear loaded on the ATV.
  • Securing ATV’s:
    • Secure ATV in its normal operating position, on all four wheels.
    • Set the parking brake and place transmission in gear.
    • Turn off fuel valve.
    • Use chocks (that fit snugly against wheels) in front and back of ATV. Front end header boards should also block forward movement of ATV.
    • Tie down ATV at each corner. Use tie downs made from one-inch nylon strap or greater, with hooks at each end and ratcheting buckles (ordinary rope should not be used due to stretching), or tie-down straps that will lock in place.
    •  ATVs should never be hauled with a load attached to the cargo racks. Hazards exist from losing the load from the ATV while in transit.

 

Category

Last Modified / Reviewed:


Have an idea or feedback?

Share it with the NWCG 6MFS Subcommittee
 


Follow NWCG on X and Facebook
 


 

NWCG Latest Announcements

Updated NWCG Standards for Wildland Fire Resource Typing, PMS 200 Now Includes Off-Highway Vehicle Typing Standards

Date: May 13, 2025
Questions?  Please contact:
Mobile Fire Equipment Subcommittee 

The NWCG Standards for Wildland Fire Resource Typing, PMS 200 has been updated to include newly developed Off-Highway Vehicle (OHV) typing standards. These standards organize OHV information into logical categories and outline key safety requirements for occupants.

NWCG Standards for Wildland Fire Resource Typing, PMS 200 establishes minimum typing standards for aircraft, crews, and equipment used in national mobilization to wildland fire incidents. Typing designations are assigned based on measurable capability and performance criteria.

References:

NWCG Standards for Wildland Fire Resource Typing, PMS 200

NEW! S-204, Interpersonal and Critical Thinking Skills for Safety Officers Now Available

Date: May 12, 2025
Questions?  Please contact:
Risk Management Committee

The S-204, Interpersonal and Critical Thinking Skills for Safety Officers self-directed online course is now available! Developed through the Incident Performance and Training Modernization (IPTM) effort, this training supports individuals working towards Safety Officer, Field (SOFF) incident qualifications.

S-204, Interpersonal and Critical Thinking Skills for Safety Officers focuses on facilitating hazard mitigation conversations and building trust to influence safety-related decisions. Individuals can self-enroll through the Wildland Fire Learning Portal (WFLP).

Any changes to qualification pathways will take effect with the next update of the NWCG Standards for Wildland Fire Position Qualifications, PMS 310-1.

References:

S-204, Interpersonal and Critical Thinking Skills for Safety Officers 

NWCG Safety Officer, Field (SOFF) Position Page

Wildland Fire Learning Portal

Great Basin Cache Upgrading to New Inventory System

Date: May 7, 2025
Questions?  Please contact:
Great Basin Cache
Phone: (208) 387-5104
Fax: (208) 387-5573

The Great Basin Cache (GBK) is transitioning to a new inventory system to better serve the wildland fire community. During this upgrade, GBK will be unable to process standard orders from Part 1: Fire Supplies and Equipment and Part 2: Publications between May 8-20, 2025, with exceptions made for emergency fire orders. Orders will be accepted through close of business May 7.

To browse the latest available items, please refer to the National Fire Equipment System (NFES) catalogs. 

References:

NWCG NFES Catalog-Part 1: Fire Supplies and Equipment, PMS 449-1

NWCG NFES Catalog-Part 2: Publications, PMS 449-2

NEW! Air Operations Summary (ICS 220 WF) Now Available

Date: May 2, 2025
Questions?  Please contact:
National Interagency Aviation Committee

The Air Operations Summary (ICS 220 WF) provides the Air Operations Branch with the number, type, location, and specific assignments of helicopters and air resources. The new ICS 220 WF also includes medical extraction capabilities and air resources tracking.

Understanding the capabilities of aviation assets is critical for effective medical and extraction responses. Coordination with the Medical Unit Leader is essential to ensure alignment and consistency between the ICS 220 WF and the Medical Plan (ICS 206 WF). 

References:

Air Operations Summary (ICS 220 WF)

National Interagency Aviation Committee

Incident Command System (ICS) Forms