Skip to main content

2023 WOR: Loop Fire (California) – November 1, 1966

 Day 1  |  Day 2  |  Day 3  |  Day 4  |  Day 5  |  Day 6  |  Day 7

 

Loop Fire (California) – November 1, 1966

Today’s topic is dedicated to all wildland firefighters.
May we never stop learning.

 

In learning from our shared history, we have the opportunity for a second chance. We ask that as you and your team read and study our wildland fire history, carefully:

 

  • Consider the facts as they are presented to you,
  • Apply all the knowledge of fire behavior and firefighting principles at your command, and
  • Add the benefit of hindsight of knowing what happened when arriving at your conclusions. In this way, we will each gain the advantage of a second chance in making these vital decisions.

The Angeles National Forest in Southern California is known for its steep, rocky terrain and common strong, dry downhill wind, known as Santa Ana winds. At 5:19 a.m., a fire was started by a faulty electric line at the Nike Missile Site on an exposed ridge at the head of Loop Canyon. Chamise, sage, and sumac were the dominant fuels, with critically low live fuel moistures. Santa Ana conditions prevailed, and the fire was driven downhill rapidly by 60 mph northeast winds toward an urban area at the bottom of the canyon.

The El Cariso Hotshots arrive at Contractors Point above Loop Canyon at 2:30 p.m. They receive instruction to leapfrog the other crews and cold trail down the east flank. Much of the fire’s edge was in or near a chimney canyon. Winds were decreasing but with continued considerable channeling and eddies. At 3:00 p.m., the El Cariso crew decided it was possible to cold trail down the chimney and tie in with the crews working the lower edge of the fire. It was noted that there was no clean black. Only 500 feet away from tying in with cat lines at the bottom at 3:35 p.m., the terrain was too steep. They decided to go indirect 50 to 100 feet away from the fire’s edge. They were working in an area of unburned fuel and hazardous topography and were unaware that the fire had established a hot spot at the base of the chimney below them, burning in sumac bushes and heavy litter. Their escape routes were inadequate. At 3:45 p.m., flare-up occurs and a “reverse tool order” (turn back and get out fast) was immediately given to the crew.

In less than 1 minute the fire flashes through the 2,200-foot chimney, overcoming the 23 firefighters. Ten will perish immediately, and two will succumb to their injuries in the coming days.

Many of us have and will likely again face a similar decision. We might easily have made the same decision King (El Cariso Crewboss) did. But HINDSIGHT and critique are giving us a second chance.

Action:

The Loop fire occurred 57 years ago, and firefighters continue to learn from this tragic event. Following this incident, the Downhill Checklist was created and is still used today.

Discussion:

How do you share your lessons learned? Big or small. How do you facilitate a learning culture in your program or organization? What was your crew or resource’s most recent teachable moment?

Resources:

6MFS Suggestion Form


Have an idea or feedback?

Share it with the NWCG 6MFS Subcommittee
 


Follow NWCG on X and Facebook
 


 

Last Modified / Reviewed:

NWCG Latest Announcements

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

Date: June 3, 2025
Questions?  Please contact:
Emergency Medical Committee

The Emergency Medical Committee has issued interim guidance for Rapid Extraction Module Support (REMS) teams. Until further notice, Type I and II REMS teams must designate a team leader qualified at Firefighter Type 1 Squad Boss (FFT1) or higher. This temporary change replaces the Single Resource Boss (SRB) requirement, which is currently not feasible due to administrative barriers.

This memorandum does not include any other changes to the NWCG Standards for Rapid Extraction Module Support, PMS 552. This interim change takes effect immediately and will remain in place until further notice.

References:

EMC Memo 25-001: Interim Rapid Extraction Module (REMS) Training and Qualification Requirements

NWCG Standards for Rapid Extraction Module Support, PMS 552

Equipment Bulletin 25-002: Chaps, Chain Saw, M-2020, Nonconformities Affecting Use, Appearance, and Serviceability

Date: June 2, 2025
Questions?  Please contact:
Equipment Technology Committee

The Equipment Technology Committee issued Equipment Bulletin: 25-002 to address a manufacturing nonconformity affecting Forest Service specification, 6170-4K Chain Saw Chaps. The issue applies to chaps manufactured in 2024 and 2025 and distributed through FedMall. These chaps may have incorrectly bound edges that expose inner protective layers.

Independent purchasers should inspect all chain saw chaps received from FedMall beginning in 2024, prior to use. Review the full Equipment Bulletin: 25-002 for inspection criteria and recommended actions.

References:

NWCG Alerts

ETC Equipment Bulletin: 25-002

2024 Wildland Fire Emergency Medical Service Awards

Date: May 22, 2025
Questions?  Please contact:
Emergency Medical Committee

The NWCG Emergency Medical Committee (EMC) is proud to announce the recipients of the 2024 Wildland Fire Emergency Medical Service Awards. Each year, EMC recognizes individuals and groups who have demonstrated exceptional actions or accomplishments that go above and beyond their normal mission or job duties.

Congratulations to all the awardees and nominees. Through leadership and initiative, they have made significant contributions to the safety and well-being of the wildland fire community. These honors are well deserved.

References:

2024 Wildland Fire EMS Awards

NWCG Emergency Medical Committee

NWCG Welcomes the Incident Management Teams Association as an Associate Member

Date: May 21, 2025
Questions?  Please contact:
https://www.nwcg.gov/contact-us

The NWCG Executive Board is honored to announce that the Incident Management Teams Association (IMTA) has joined the National Wildfire Coordinating Group as an associate member.

IMTA is a dedicated group of incident management professionals committed to enhancing the profession by promoting standards and fostering collaboration across federal, state, local, Tribal, and private sector partners throughout all phases of incident management.

“Joining NWCG aligns with our mission to elevate incident management professionals nationwide,” said Dr. Randal Collins, President of IMTA. “This is a proud moment for all of us committed to advancing public safety.”

References:

Incident Management Teams Association

National Wildfire Coordinating Group